0100481860

open access

Version of Record

Automated Generation of Product Assembly Order Based on Geometric Constraints Between Parts

English (英語)

International Journal of Automation Technology

17(2)

167-175

富士技術出版

2023-03-05

2023-04-21

This study proposes a method for automating the determination of assembly order by automating the derivation of the necessary connection relationships between the parts. The proposed method minimizes the information required for the initial conditions and automatically determines the feasible assembly orders. As a general rule, based on the assumption that the assembly order for a product is the reverse of the disassembly order, once the disassembly order is derived based on the 3D CAD model and the connection relationships between the parts, the assembly order can be determined. Until now, however, the relationships between the parts are decided manually by the attendant engineers, thus, hindering the full automation of the determination of the assembly order. To achieve full automation realistically, the connection relationships between the parts should be derived automatically from the 3D CAD model, for which this study proposes an efficient method. The components were extracted from the 3D CAD model, and the bolts were identified. The connection relationships between the parts were derived from the interference conditions determined while moving each part minutely. An association chart diagram was created from the obtained connection relationships, from which multiple assembly order candidates could be derived.

CAD

学術雑誌論文

This is an Open Access article distributed under the terms of the Creative Commons Attribution-NoDerivatives 4.0 International License