0100495806

open access

Version of Record

Amount of mechanical hip-knee-ankle (mHKA) angle correction by fixed-bearing medial UKA can be predicted using a new morphological assessment method: the arithmetic hip-knee-ankle (aHKA) angle

English (英語)

Archives of Orthopaedic and Trauma Surgery

145(1)

271

Springer Nature

2025-04-26

2025-05-07

Introduction: The amount of change in coronal alignment by unicompartmental knee arthroplasty (UKA) is important when considering its long-term results. This study investigated whether the amount of change in mechanical hip-knee-ankle (mHKA) angle by medial fixed-bearing UKA can be predicted based on the arithmetic hip-knee-ankle (aHKA) angle, an indicator of bony nature that is independent of soft tissue balance. Materials and methods: The research involved 101 patients (125 knees) who underwent medial fixed-bearing UKA with the spacer-block technique. Pre- and postoperative mHKA angles, aHKA angle (180°– lateral distal femoral angle + medial proximal tibial angle), insert thickness, and the amount of bone cuts were measured. The component gap in extension was measured using a UKA tensor, and the pre-osteotomy gap was calculated. The correlation between aHKA angle minus preoperative mHKA angle and changes in mHKA angle, as well as the pre-osteotomy gap, were analysed. Additionally, changes in mHKA angle and total osteotomy volume were compared based on insert thickness. Results: A positive correlation was found between aHKA angle minus preoperative mHKA angle and the change in mHKA angle. The pre-osteotomy gap was also positively correlated with aHKA angle minus preoperative HKA angle. Greater changes in mHKA angle occurred in cases with inserts ≥ 9 mm compared to 8 mm inserts, though osteotomy volume did not significantly differ between the groups. Conclusions: In fixed-bearing UKA, postoperative changes in mHKA angle are likely to be more pronounced when there is a significant difference between aHKA angle and preoperative mHKA angle. Surgical planning should account for this factor to optimise outcomes.

Insert thickness

学術雑誌論文

This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder.